Table of Contents
Advertisement
ID/
LOC.
PART
Fig.
No.
No.
Deck
[24]
D9 7(S-28)
Pedestal
Front
[25]
D9
Bracket R
[26] Bracket R
D9 2(S-31)
p
p
p
(1)
(2)
(3)
Note:
(1): Identification (location) No. of parts in the figures
(2): Name of the part
(3): Figure Number for reference
(4): Identification of parts to be removed, unhooked,
unlocked, released, unplugged, unclamped, or
desoldered.
P=Spring, L=Locking Tab, S=Screw,
CN=Connector
*=Unhook, Unlock, Release, Unplug, or Desolder
e.g. 6(S-1) = six Screws (S-1),
5(L-1) = five Locking Tabs (L-1)
(5): Refer to "Reference Notes."
REMOVAL
REMOVE/*UNHOOK/
UNLOCK/RELEASE/
Note
UNPLUG/DESOLDER
(S-29), 2(S-30), DV
Cable, DV Plate Earth
p
(4)
Reference Notes
1. Locking Tabs (L-1) and (L-2) are fragile. Be careful
not to break them.
1-1. Remove Screw (S-2).
1-2. Release four Locking Tabs (L-1).
---
1-3. Release three Locking Tabs (L-2).
1-4. Disconnect Connector (CN6001), and
---
remove the Front Assembly.
---
2. The DVD Mechanism & DVD/HDD MAIN BOARD
p
Assembly is adjusted as a unit at factory.
Therefore, do not disassemble it. Replace the
(5)
DVD Mechanism & DVD/HDD MAIN BOARD
Assembly as a unit.
3. Whenever you have replaced the HDD unit, format
the HDD unit. To format the HDD unit, perform the
following.
3-1. To put the HDD & DVD/VCR into the HDD
mode, press the [HDD] button on the remote
control unit.
3-2. To put the HDD & DVD/VCR into the self-
check mode, after pressing [VARIABLE
SKIP] button, press the [0], [7], and [9]
buttons on the remote control in that order
within three seconds.
3-3. Press [ENTER/OK] button. The HDD & DVD/
VCR is formatted and the power is turned off
automatically after two seconds.
4. When reassembling, solder wire jumpers as
shown in Fig. D8.
5. Before installing the Deck Assembly, be sure to
place the pin of LD-SW on the BOARD AV as
shown in Fig. D8. Then, install the Deck Assembly
while aligning the hole of Cam Gear with the pin of
LD-SW, the shaft of Cam Gear with the hole of LD-
SW as shown in Fig. D8.
[1] Cover Top
(S-1)
1-7-2
(S-1)
(S-1)
(S-1)
Fig. D1
E3TK0DC
Advertisement
Table of Contents
