Aoutside Top Exhaust; Attach Mounting Plate To Wall - GE ZSA1201 Installation Instructions Manual

A
OUTSIDE TOP EXHAUST
INSTALLATION OVERVIEW
A1. Attach Mounting Plate to Wall
A2. Prepare Top Cabinet
A3. Install Adaptor
A4. Mount Oven
A5. Adjust Exhaust Adaptor
A6. Connect Ductwork
ATTACH THE MOUNTING
A1
PLATE TO THE WALL
A
C
Attach the plate to the wall using toggle bolts. At
least one wood screw must be used to attach the
plate to a wall stud. Recommended locations on the
mounting plate are indicated by A, B, C and D.
1 Remove the toggle wings from the bolts.
2
Insert the bolts into the mounting plate through the
holes designated to go into drywall and reattach
the toggle wings to
12
Installation Instructions
B
D
3 4
(Vertical Duct)
To use toggle bolts:
Spacing for
Toggles More Than
Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
Place the mounting plate against the wall and
3
insert the toggle wings into the holes in the wall to
mount the plate.
NOTE: Before tightening toggle bolts and wood
screw, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed
flush against the wall and that the plate is properly
centered under the cabinet.
CAUTION
Be careful to avoid pinching
fingers between the back of the mounting plate
and the wall.
4
Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
Bolt End
49-40650-5