Fujitsu Plasmavision PDS4203 User Manual page 12

NAMES OF PARTS AND THEIR FUNCTIONS
Power switch
• When pressed, power lamp
can be turned on or off by the remote controller. When
this switch is pressed again, the power is cut and
power lamp goes off.
Power input terminal
• Firmly insert the accessory power cord as far as it will
go into the power input terminal.
• Firmly push the power cord plug as far as it will go
into the power socket. (100–240 VAC)
Video input terminal (VIDEO INPUT)
• Connects to the video output terminal of a video deck
or video disc player.
S video input terminal (S-VIDEO INPUT)
• Connects to the S video output terminal of a video
deck or video disc player.
Component video input terminal (COMPONENT
VIDEO INPUT)
• Connects to the component video output terminal of
DVD and similar devices.
1 2
Rear view
lights red, and the power
RGB input terminal (RGB INPUT)
• Connects to the computer monitor's (analog RGB)
output terminal.
Cables connecting the personal computer vary ac-
cording to the type of machine, so consult your prod-
uct dealer.
RS-232C input terminal (RS-232C)
• Connects to the computer RS-232C output terminal.
Audio input terminals (AUDIO INPUT)
• Connects to the audio output terminal of a video deck
or similar device.
Sync switch (SYNC SW TTL/ANALOG (75
• For switching the RGB terminals' 13-pin horizontal
sync and 14-pin vertical sync to terminate with 75
When an analog synchronous signal is input at the
RGB terminal, be sure that this switch is set to ANA-
LOG (75 ). For connection to a personal computer,
be sure it is set to TTL.
)
.