Table of Contents
Advertisement
When you save the settings, the web page will be refreshed slowly, please wait it finished.
Some settings only take effect after rebooting the router.
3.4 WAN CONFIGURATION
If the configuration is bridge encapsulation, there is no need to configure any more parameters. Only need
to use the third party dial-up software to connect the Internet.
Totally, this router supports：PPPoA, PPPoE, MER, IPoE, IPoA, Bridging. For detail configuration
information, please check the following configuration guide.
3.4.1 VIEW WAN SERVICE
Click "Device Info" on the left page, and enter into "WAN" page.
l
NOTE: At most we can support eight connections. We support edit non-bridge wan connections.
There is no need to reboot the device when you add/remove/edit one wan connection. It takes effect
immediately.
3.4.2 RFC1483 BRIDGE ON ATM CONFIGURATION
Click "Advanced Setup" on the left page, and enter into "Layer2 Interface" configuration page, where we can
select the type of Layer2-Interface ATM.
l
NOTE: ATM interface is our most commonly used mode, which will transport data on DSL line via
Bridge or Route Connections.
Select ATM Interface, then click "Add" button to add one NEW Interface of Layer2.Then input Appropriate
VPI/VCI, select EOA used for IPoE , PPPoE, Bridge, and select Encapsulation Mode and Service Category,
Connection Mode (Default, VLAN-MUX, MSC). If QOS need, please select "Enable quality Service". Usually,
you only need to setup VPI/VCI to the value assigned by your ISP .At last click "Apply /Save" button to save
the configuration.
Figure 3.2
Page 7
DSL Gateway/Router — User Manual
Total 24 Pages
Advertisement
Table of Contents
