Fujitsu ScanSnap S1500M Getting Started Manual page 7

6.
Check the [ScanSnap Manager] icon.
⇒
The [ScanSnap Manager] icon should be dis-
played in the taskbar.
It will take a few moments until the
ScanSnap is ready to be used, and the
[ScanSnap Manager] icon changes to
on the taskbar.
⇒
The [ScanSnap Manager] icon should be dis-
played in the Dock.
It will take a few moments until the
ScanSnap is ready to be used, and the
[ScanSnap Manager] icon changes to
in the Dock.
⇒
Connecting the ScanSnap to your computer is
complete. Proceed to
Document Scan Test
After installing the software and connecting the Scan-
Snap and computer, use ScanSnap Manager and check
that documents can be scanned.
The following describes the document scan test proce-
dure.
This describes the Quick Menu scanning
method. For other scanning methods, refer to
the Operator's Guide.
" "
Document Scan Test .
1.
Load the test documents into the
ScanSnap.
1. Pull the stacker on the ADF top section
towards you.
2. Prepare to load the document as follows.
Pull out the extension
Open the side
guides
Raise the
stacker
3. Load the test documents on the ADF paper
chute (cover), and adjust the side guides to
the size of the documents.
Set the documents
face-down and top-first
7
Stacker