Table of Contents
Advertisement
Leg Installation/Adjustments/Alignment
Tecnogas ranges must be used only with
the legs properly installed.
Four height adjustable legs, assem-
bled under the bottom of the range
Four height adjustable legs are delivered
with the range in the polysterene contai-
ner situated over the appliance.
Before installing the legs, position the
appliance near its final location as the legs
are not suitable for moving the appliance
over long distances.
After unpacking the range, raise it enough
to insert the legs in the appropriate
receptacles situated on the lower part
of the appliance. Lower the range gently
to keep any undue strain from legs and
mounting hardware. If possible use a pal-
let or lift jack instead of tilting the unit.
Adjust leg height to the desired level by
twisting the inside portion of the leg as-
sembly until the proper height is reached.
Check with a level that the worktop
allignement is perfectly level.
insert the legs in the appropriate
receptacles
Remember that is indicated to set the
high corner of range so that the top of
side trim is 3/8" (0.95 cm) above coun-
tertop.
(see paragraph "Dimension")
23
Advertisement
Table of Contents
