Source 1 S1-TBSU306-S Owner's Manual & Installation Instructions page 12

Quick Start
Viewing the Temperature Sensors
ACCESRY
STATUS
Press ACCESSRY STATUS to view the current values of optional
outdoor and remote/supply temperature sensors. If connected to a
Skyport account, the temperature for the location you set up in the account
®
will be shown if you don't have a wired sensor connected. The high/low
outdoor temperature will also be shown (resets at midnight). Press MODE to
move between sensors and enter the actual Wi-Fi accessory status section.
Setup step #44 selects the use of the wired temperature sensor. Press
ACCESSRY STATUS again to return to the main screen.
HUMIDITY
Viewing the Indoor Humidity Sensor
IMPORTANT: Allow at least 2 minutes after the thermostat is
powered on for the humidity to read correctly.
Press the HUMIDITY button, then the mode button to display the current
humidity measured at the thermostat. The room's relative humidity is displayed
in the top left corner. The humidification setpoint appears in the larger, center
display and can be adjusted using the WARMER or COOLER buttons. Press the
MODE button again to view and adjust the dehumidification setpoints. Press
the HUMIDITY or MODE button again to confirm settings and return to normal
operation.
Note: Due to variations in environmental and equipment conditions, it is not
always possible to achieve the desired humidification or dehumidification
setpoint.
8