Table of Contents
Advertisement
PROFESSIONAL INSTALLATION IS
STRONGLY RECOMMENDED
Roll down window to avoid locking the keys in the vehicle during
installation
Avoid mounting components or routing wires near hot surfaces
or near moving parts like the steering wheel as it may prevent
proper operation of the vehicle
Tape or loom wires under the hood and dash for protection as
well appearance
Use grommets when routing wires through metal surfaces to pre-
vent chafing and shorting
Use a Digital Multi Meter for testing and verifying circuits. DO
NOT USE A "TEST LIGHT" OR "COMPUTER SAFE PROBE" as
these can set off air bags or damage sensitive vehicle computers
and electronics
For technical support go to www.avxtech1.com
FCC COMPLIANCE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
FCC COMPLIANCE
(1) This device may not cause harmful interference, and
This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada.
(2) this device must accept any interference received, including interference that may cause undesired operation.
Operation is subject to the following two conditions:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
1. This device may not cause harmful interference, and
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
2. This device must accept any interference received, including any interference that may
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off
cause undesired operation.
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
Warning!
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Changes or modifications not expressly approved by the party responsible for
—Consult the dealer or an experienced radio/TV technician for help.
compliance could void the user's authority to operate the equipment
Warning!
NOTE:The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to
Changes or modifications not expressly approved by the part responsible for compliance could void the use's authority to operate the equipment
this equipment. Such modifications could void the user's authority to operate the equipment
NOTE:The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this
equipment. Such modifications could void the user's authority to operate the equipment.
Before You Begin
or call 1 800 225 6074
.
2
128-9447
2 of 28
Advertisement
Table of Contents
