Basic Operation; Power On; Placing A Call; Receiving A Call - LG LST-230 User Manual

Cdma fixed terminal
Table of Contents

Advertisement

LGIC CDMA Fixed Wireless Terminal
LST-230(F) / 2300(F)
3
.
B
a
s
i
c
O
p
e
3
.
B
a
s
i
c
O
p
e

3.1 Power On

1. The POWER LED indicates the presents status;
1)
Using AC Adapter : Solid Green
2)
Using internal battery : Solid ORANGE
3)
Using internal battery and battery is week : Solid Red
2. If the radio service is not available or radio signal is too weak to detect;
The SIGNAL LED is Red. (No Service status)
3. When the phone is succeeded in getting the service, SIGNAL LED indicates the strength of the signal.
1)
Lifting handset, dial tone is heard and you can enter a phone number.
(Not entering any key for 15 seconds (In the overlap dial mode, it may take over 15
tone will be produced)
*) If Hot Line function is enabled, busy tone is not produced and hot line number is automatically
connected.
*) While having maintenance request order or lock order from the main system, neither dial tone nor busy
tone is produced. Instead of them, the lock tone("pi-pi-pi") will be heard one time and there will be no
sound and both of MODE LED and POWER LED will be blinking with GREEN color simultaneously.

3.2 Placing a call

When lifting handset of the connected phone ("off hook"), the terminal determines whether cellular service is
available. If it is available, dial tone is produced and a number can be dialed normally. If phone service is not
available, SIGNAL LED of the terminal will be red and no dial tone will be heard.

3.3 Receiving a call

The connected telephone rings when an incoming call is detected. Pick up the handset and begin talking.

3.4 Ending a call

When you have completed the call, place the handset back on hook. Also you can hook flash more than about 1
second to end a call and place a new call without hanging up the handset.

3.5 Warning Tone after Remote Disconnect

A warning tone may be heard in the telephone after a remote party hangs up from a call, allowing another call to
be initiated after hook-flash.

3.6 Dial Delay(Enblock mode only)

The terminal waits 5 seconds before transmitting the dialed telephone number into the cellular network.
r
a
t
i
o
n
r
a
t
i
o
n
15
seconds.) warning

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lst-230fLst-2300Lst-2300f

Table of Contents