Advertisement
Operation:
Install the tube into the bottom of the yeast harvester body.
Ensure the o-ring is seated in place shown in figure 1.
Install the Yeast Harvester as shown
in figure 3 with a 1.5" tri-clamp and
gasket.
Tighten the collection bottle to the
harvester body and remove the gas
ball lock.
Yeast Harvesting Kit
© Blichmann Engineering, LLC 2021
For replacement parts, visit: blichmannengineering.com/genuine-replacement-parts
Figure 1
Figure 3
Figure 4
Slowly loosen the collection bottle to
allow air pressure to release out the
top.
Figure 6
Ensure the o-ring is seated on the ball
lock post shown in figure 2.
Figure 5
Attach the gas ball lock and introduce
CO2 into the collection bottle. Two to
three seconds of purging at 10psi is
sufficient.
Slowly open the valve to allow the
yeast to into the bottle. After you have
harvested your yeast, close the valve
and slowly unscrew the bottle to gen-
tly relieve the pressure.
Figure 2
Figure 7
3
Advertisement
