Blichmann Tower of Power Instructions Manual

Controller factory reset

Download this manual

Blichmann Tower of Power Controller Factory Reset Instructions

If the Blichmann Factory Settings have been altered follow instructions below to set/verify the correct

settings. The photos below each line of instruction shows what the controller display should look like

upon completion of the step above the photo. Ensure that temperature probe is connected to ToP

controller. Blichmann Factory Reset Instructions

These instructions describe how to return or verify setting of a Tower of Power controller to Blichmann

Factory settings. It is important to read the instructions and follow all instructions in order. The

temperature sensor must be plugged in for these instructions.

Step 1. Press the ENTER and NEXT keys simultaneously to unlock the controller.

Step 2. Press ENTER again while at the Home Display in order to access the Regulation Settings Menu.

Step 3.

Verify the setting. If the setting is not as the same as in image change to appropriate setting

using the UP and DOWN arrows and then press ENTER to save this value. Press the NEXT button for each

setting until you reach the final setting.

Need help?

Do you have a question about the Tower of Power and is the answer not in the manual?

Page 1 Ensure that temperature probe is connected to ToP controller. Blichmann Factory Reset Instructions These instructions describe how to return or verify setting of a Tower of Power controller to Blichmann Factory settings. It is important to read the instructions and follow all instructions in order. The temperature sensor must be plugged in for these instructions.
Page 2 Repeat Step 3 for each subsequent setting.
Page 4 Step 4. Press ENTER. Step 5. Press and hold the ENTER key for 5 seconds until the Home Display flashes in order to access the Initial Setting Menu. STEP 6. Verify the setting. If the setting is not as the same as in image change to appropriate setting using the UP and DOWN arrows and then press ENTER.
Page 8 Step 7. Press ENTER Step 8. Press NEXT again while at the Home Display in order to access the Operation Settings Menu. Step 9. Verify the setting. If the setting is not as the same as in image change to appropriate setting using the UP and DOWN arrows and then press ENTER.
Page 9 Repeat Step 9 for each subsequent setting. Step 10. Press ENTER.
Page 10 Step 11. Press NEXT three times to enter this screen. Step 12. Change the LoC setting to LoC 2 using the UP arrow. Press ENTER and this will restore the Blichmann Factory settings and prepare the controller for use. The final screen should be the temperature settings...