Memory Upgrade Module; Installing Memory Upgrade Modules; To Remove A Memory Upgrade Module - Fujitsu Lifebook S6010 User Manual

Memory Upgrade
Module
Your Fujitsu LifeBook notebook comes with either
128MB or 256MB of high speed Synchronous Dynamic
RAM (SDRAM), 133MHz factory installed. To increase
your LifeBook notebook's memory capacity, you may
install an additional memory upgrade module. The
memory upgrade must be a dual-in-line (DIMM)
SDRAM module. To ensure 100% compatibility,
purchase the SDRAM module only from the Fujitsu web
store at www.fujitsupc.com.
C A U T I O N S
I Do not remove any screws from the memory upgrade
module compartment except the ones specifically
shown in the directions for installing and removing
the memory upgrade module.
I The memory upgrade module can be severely dam-
aged by electro-static discharge (ESD). Be sure you
are properly grounded when handling and installing
the module.

INSTALLING MEMORY UPGRADE MODULES

1. Turn off power to your LifeBook notebook using the
power switch, and remove any power adapter
(AC or auto/airline).
2. Make sure that all the connector covers are closed.
3. Turn the notebook bottom side up, with the front
panel toward you.
4. Remove the screws of the memory upgrade module
compartment. (Figure 4-7)
5. Remove the cover.
Figure 4-7 Opening the Memory Upgrade Compartment
6. Remove the memory upgrade module from the
static guarded sleeve.
P O I N T
There are two memory module slots stacked atop one
another in the memory module compartment. If you are
adding a second module, the top slot will be empty.
U s e r I n s t a l l a b l e F e a t u r e s
7. Align the memory upgrade module with the part
side up. Align the connector edge of the memory
upgrade module with the connector slot in the
compartment. The connector will be pointing
toward the rear of the notebook.
8. Insert the memory upgrade module at a 45° angle.
Press the connector edge of the module firmly down
and into the connector until it lodges under the
retaining clip. You will hear a click when it is prop-
erly in place. (Figure 4-8)
Figure 4-8 Installing a Second Memory Module
9. Replace the cover.(Figure 4-9)
10. Replace the screws.
Figure 4-9 Replacing the Memory Compartment Cover
P O I N T
The memory upgrade module is not something you
routinely remove from your notebook. Once it is
installed, you can leave it in place unless you want to
change system memory capacity.

TO REMOVE A MEMORY UPGRADE MODULE

If you have a single module installed:
1. Perform steps 1 through 5 of Installing a Memory
Upgrade Module.
2. Pull the clips sideways away from each side of the
memory upgrade module at the same time.
3. While holding the clips out, remove the module
from the slot by lifting it up and pulling towards the
rear of your notebook. (Figure 4-10)
45