Floppy Disk Drive Problems; Hard Drive Problems; Keyboard Or Mouse Problems - Fujitsu Lifebook P5010 User Manual

Problem
The DVD/CD-RW Access
indicator on the Status
Indicator Panel blinks at
regular intervals when no
DVD/CD-RW disc is in the
tray or the drive is not
installed.

Floppy Disk Drive Problems

You cannot access your
optional floppy disk.

Hard Drive Problems

You cannot access your
hard drive.

Keyboard or Mouse Problems

The built-in keyboard does
not seem to work.
The characters that appear
do not match those which
you typed.
You have installed an
external keyboard or
mouse, and it does not
seem to work.
Possible Cause
The Windows DVD/CD-RW
auto insertion function is
active and is checking to see if
a DVD/CD-RW disc is ready to
run.
You tried to write to a write
protected floppy disk.
Floppy disk is not loaded
correctly.
Security is set to protect access
to floppy disk data.
The setup utility is incorrectly
set for your internal (Primary
Master) or optional second
hard drive (Primary Slave).
The wrong drive designator
was used by an application
when a bootable CD-ROM was
used to start the notebook.
Security is set so your oper-
ating system cannot be started
without a password.
The notebook has gone into
Suspend mode.
Your application has locked
out your keyboard.
NumLock is set in the BIOS.
Your external device is not
properly installed.
Your operating system
software is not setup with the
correct software driver for that
device.
T r o u b l e s h o o t i n g
Possible Solutions
This is normal. However, you may disable this
feature. (See Auto Insert Notification Function on
page 36 for more information)
Eject the floppy disk and set it to write enable. (See
Preparing a Disk for Use on page 44 for more informa-
tion)
Eject floppy disk, check orientation and re-insert.
(See Ejecting a Disk on page 44 for more information)
Verify your password and security settings.
Revise BIOS settings to set both Primary Master
and Primary Slave correctly. (See BIOS Setup Utility
on page 25 for more information)
Verify drive designator used by application is in
use by the operating system. When the operating
system is booted from a CD, drive designations
are automatically adjusted.
Verify your password and security settings.
Push the Suspend/Resume/Power On button.
Try to use your integrated pointing device to restart
your system. If this fails, turn your notebook off
using the Power Off button located on the back of
the system. Wait 10 seconds or more, and then turn
the system back on.
Go to the BIOS and make sure that NumLock is
disabled. (See BIOS Setup Utility on page 25 for more
information)
Re-install your device. (See Device Ports on page 45
for more information)
Check your device and operating system docu-
mentation and activate the proper driver.
79