Table of Contents
Advertisement
Automatic fault warnings and what to do
ERROR CODE
FF
F5
F3
F2
F8
F1
FE
F7
F6
F9
HI
LO
The installation and repair procedures should always be carried out by the Authorised Service Agent, in order to avoid possible
risks. The manufacturer shall not be held liable for damages that may arise from procedures carried out by unauthorised
persons. Repairs may be carried out by technicians only. If a component has to be replaced, ensure that only original spare
parts are used.
Improper repairs or use of non-original spare parts may cause considerable damage and put the user at considerable risk.
Contact information for your customer service can be found on the back of this document.
Function-relevant genuine spare parts according to the corresponding Ecodesign order can be obtained from Customer
Service for a period of at least 10 years from the date on which your appliance was placed on the market within the European
Economic Area.
POSSIBLE FAULT
Water inlet system failure
Pressure system failure
Continuous water input
Inability to discharge water
Heater error
Overflow
Faulty electronic card
Overheating error
Faulty heater sensor
Divisor position error
High voltage failure
Low voltage failure
15
WHAT TO DO
Make sure the water inlet tap is open and water is flowing.
Separate the inlet hose from the tap and clean the filter of
the hose.
Contact for service if the error continues.
Contact for service.
Close the tap and contact for service.
Water discharge hose and filters may be clogged.
Cancel the program.
If the error continues, contact for service.
Contact for service.
Unplug the machine and close the tap.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
Contact for service.
Advertisement
Table of Contents
