Memory Problems; Modem Problems; Parallel, Serial And Usb Device Problems; Pc Card Problems - Fujitsu Lifebook E8020 User Manual

E8020.book Page 56 Thursday, March 10, 2005 1:55 PM
L i f e B o o k E 8 0 0 0 N o t e b o o k
Problem
You have installed an Your operating system soft-
external keyboard or ware is not set up with correct
mouse, and it does not software driver for that device.
seem to work.
Your mouse or keyboard is
(continued) connected to the wrong PS/2
port on the optional Port
Replicator.
You have connected an Your operating system soft-
external keyboard or a ware is not setup with correct
mouse and it seems to be software driver for that device.
locking up the system.
Your system has crashed.

Memory Problems

Your Power On screen, or Your memory upgrade module
Main menu of the BIOS is not properly installed.
setup utility information,
does not show the correct
You have a memory failure.
amount of installed
memory.

Modem Problems

Messages about modem Messages about modem
operation. operation are generated by
whichever modem application
is in use.
Parallel, Serial, and USB Device Problems
You have installed a parallel The device is not properly
port device, a serial port installed.
device or a USB device.
The device may have been
Your LifeBook notebook
installed while an application
does not recognize the
was running, so your notebook
device, or the device does
is not aware of its installation.
not seem to work properly.
Your device may not have the
correct software driver active.
You may have the wrong I/O
address selected for your
device.
Your device and another device
are assigned the same I/O
address.
Parallel port is set to output
only.

PC Card Problems

A card inserted in the PC The card is not properly
Card slot does not work or installed.
is locking up the system.
56
Possible Cause
Check your device and operating system docu-
mentation and activate the proper driver.
Plug the mouse into the PS/2 Mouse port and
the external keyboard into the PS/2 Keyboard port.
(See PS/2 Port on page 49 for more information)
Check your device and operating system
documentation and activate the proper driver.
Try to restart your notebook. I
Remove and re-install your memory upgrade
module. (See Memory Upgrade Module on page 46
for more information)
Check for Power On Self Test (POST) messages.
(See Power On Self Test Messages on page 62 for more
information)
See your application software documentation for
additional information.
Remove and re-install the device. (See Device Ports
on page 48 for more information)
Close the application and restart your notebook.
See your software documentation and activate the
correct driver.
See your device documentation and software docu-
mentation to determine the required I/O address.
Change the settings in the BIOS setup utility. (See
BIOS Setup Utility on page 29 for more information)
Check all I/O addresses located within the BIOS
setup utility and any other installed hardware or
software to make sure there are no duplications.
Check parallel port setting in the BIOS and set to
bi-directional or ECP.
Remove and re-install the card. (See PC Cards/
ExpressCards™ on page 44 for more information)
Possible Solutions