Advertisement
There is one signal field adjustment knob on the ICT 801 transmitter and two signal field
adjustment knobs on the ICT 802 transmitter. Turning the signal field adjustment knob
clockwise increases the signal field width. Conversely, turning it counter-clockwise
decreases the signal field width.
IMPORTANT: These adjustments do not change the correction level of the Invisible
Fence
Brand Computer Collar
®
Check the width of the signal field from only one place on the signal field loop wire. Always
check the signal field width from the same place. Take the Computer Collar
to measure the signal field width.
IMPORTANT: Invisible Fence
mechanism. Should the pet become caught in the signal field, the Computer Collar
goes through a cycle of 10 seconds ON, 10 seconds OFF, and then shut down. The collar will
not reactivate until it is completely removed from the signal field, and then brought back
into it.
Computer Collar
®
Invisible Fence
Brand Computer Collar
®
powered by a Power Cap
unit; it only changes the width of the signal field.
®
Brand Computer Collar
®
Unit
unit.
®
1. Hold the Invisible Fence
Computer Collar
the signal field wire.
2. Hold the collar so it is about the same
height and at the same angle as it will be
when the pet is wearing it.
3. Walk slowly toward the signal field
wire. The unit will activate when you
reach the edge of the signal field. Do NOT
touch the correction posts at this time!
units are microprocessor-controlled units
®
21
unit off the pet
®
Brand
®
unit so it is parallel to
®
units have a fail-safe
®
unit
®
Advertisement
