Advertisement
a. For ICT 801: The L1 Freq. LED begins to blink.
b. For ICT 802: The Loop 1 LED begins to blink.
2. Release the S1 button.
3. Momentarily press and release the S2 button to toggle between each setting option.
4. Press and release the S1 button to move to the next setting.
5. Continue until all choices are selected.
6. The cursor LED will stop blinking approximately ten seconds after the buttons are
released, and the transmitter will automatically exit the programming mode.
IMPORTANT: If the transmitter is disconnected from the power source while the
system indicator lights are still blinking, the settings will not be saved to system memory.
Audible Alarm: There is an audible alarm for certain alert conditions (See table below).
Press and release either the S1 or the S2 button on the circuit board to silence the alarm.
The alarm will re-activate on power-up, or when exiting set-up mode (if a failure condition
still exists).
Primary Power
Primary power to the unit shall be provided by:
ICT 801 Transmitter: AC Adapter Model RAC00-12612 (Universal transformer)
Setting the Signal Field Width
The signal field is what activates the Computer Collar
be set to various distances from the signal field wire. The distance from the wire loop to the
edge of the signal field is called the signal field width.
LED Status Indicator Light
unit. The edge of the signal field can
®
20
Advertisement
