Fujitsu Lifebook C352 Manual page 114

Batteries can, of course, also be "cold-swapped",
i.e. with the notebook powered off and the AC
adapter disconnected. In this case there is not
time limit.
Replacing the Battery
The battery is installed in the battery bay on the
underside of your notebook. (See Figure 5-1.)
With the purchase of an additional battery, you
can have a fully charged spare to swap with one
that is not charged. To swap batteries, have a
charged battery ready to install and follow the
steps below:
1. Press the Power button to put the notebook
into suspend mode. (Or shut down your
notebook and disconnect the AC adapter if
you wish to cold-swap.)
2. Close your display and turn your notebook
over on a flat surface.
3. Detach the cover of the battery bay.
4. Slide the battery pack away from the connector.
5. Remove the battery from the bay by tilting it
upwards and taking it out of the bay.
U s e r I n s t a l l a b l e
6. Insert a new battery by placing it in the bay
with the connector end up and then lay it flat.
7. Slide the new battery onto the connector.
8. Replace the battery bay cover making sure it
locks in place.
9. Press the Power button to resume from
suspend mode if you are warm-swapping, or
to power on your notebook if cold-swapping.
Batteries should be removed and stored
separately in a cool dry place if your notebook
is not going to be used for an extended period
of time.
L i f e B o o k C S e r i e s f r o m F u j i t s u
F e a t u r e s
C A U T I O N
If the Lithium ion battery connector is not
fully seated, you may not be able to use
your notebook or charge your battery.
Figure 5-1 Replacing the Battery
107