Advertisement
Quick Links
Advertisement
Related Manuals for Ventair Mixflow
Summary of Contents for Ventair Mixflow
- Page 1 INSTRUCTIONS...
- Page 2 Model:VMFIL100, VMFIL150, VMFIL200, In-line Exhaust Fan The VMFIL mixflow range in-line exhaust fan that has been manufactured in accordance with the rigorous standards of production as defined by the International Quality Standards ISO 9001.All the components have been checked and tested at the end of the manufacturing process.
- Page 4 Duct work connection should be made with duct tape or duct fast-clamps (available through your local distributor hardware retail store) to ensure a good seal and secure connection. INSTALLATION-Applications,Recommendations&Wiring Installation tips: Figure 1.Typical Appliations Multi-Point Exhaust System :Model:VMFIL series...
- Page 5 To start the installation the motor wheel assembly must first be removed, loosening the two spring clips around the casing and remove. (Step 1-3 diagram below). 2.Secure the mounting bracket fan flange assembly to a fixed structure. (Step 4-5 diagram below). 3.Replace the fan motor wheel assembly and tighten the two spring clips to secure the product.(Step 6-8 diagram below).
- Page 6 Warning:All electrical connections and disconnections must be performed by a Licensed Electrician. Wiring diagram Warning:For your safety,all electrical work must be carried out by a licensed electrcian.All electrical wiring must be in accordance with latest national wiring rules AS/NZS 3000. Warning:Ensure the power supply to the exhaust fan is switched OFF before carrying out any installation and maintenance Note:A double switch must be included in the electrical wiring of the...
- Page 7 IMPORTANT:An additional all pole diconnection switch MUST be cluded in the fixed wiring to provide isolation for maintenance. MAINTENANCE IMPORTANT:BEFORE CARRYING OUT ANY MAINTENANCE OR SERVICING,ENSURE THE UNIT IS DISCONNECTED FROM THE MAIN ELECTRICAL SUPPLY. This exhaust fan incorporates fully sealed bearings and therefore does not require any lubrication .We would recommend inspection of the product at least once every twelve(12) months to avoid the excessive accumulation of dust and dirt on the inpeller.
- Page 8 VMFIL100 VMFIL150 VMFIL200 30Watts 50Watts 130Watts Max.Air Flow 561/438m /h 240/190m /h 852/753m /h Rate (H-L): Electrical...