Table of Contents
Advertisement
2
Assign a Management IP address and subnet mask to the Switch; the
Default Gateway address is optional and can be added later (refer to
"Startup Configuration Requirements" for descriptions of the
required fields).
3
If you have more than one Switch, click Search to automatically add the
additional Switch serial numbers. To verify the switches that have been
discovered, you can refer to the serial number on the bar code on the bottom
of the Switch.
4
Click Apply to configure the Management IP address, subnet mask,
and default gateway on the Switch. The Extranet Address Configuration
Utility display disappears.
5
When the Switch has completed updating its configuration with the
Management IP address, subnet mask, and optional default gateway, your
default Web browser will open automatically to the Contivity Extranet Switch
Welcome display.
6
Click Close to shut down the Extranet Address Configuration Utility.
Serial interface configuration
Use the IP Address Configuration Utility to configure the Switch with its initial IP
address.
Alternatively, you can use the serial interface configuration menu to access the
Switch via the serial interface of your PC. The serial interface configuration menu
allows you to give the Switch a Management IP address, subnet mask, and
gateway IP address so that you can use a Web browser for management.
Note: Before moving the Switch from one network to another, change
the Management IP address, subnet mask, and default gateway.
Otherwise, you will need to follow the Serial Interface Configuration
procedure to access your Switch because it will not be accessible from a
Web browser with an invalid address.
Chapter 5 Assigning a System Identity 61
Getting Started with the Contivity 600
Advertisement
Table of Contents
