M A X I M U M R E C O M M E N D E D W E I G H T L O A D S MANUFACTURER: Whalen Furniture Manufacturing CATALOG: Whitney Lateral File MODEL # SPLS-WHLF-TV MAXIMUM LOAD 22.7 kg / 50 lb.
Page 3
FURNITURE TIPPING RESTRAINT YOUNG CHILDREN MAY BE INJURED BY TIPPING FURNITURE AND YOU MUST USE THIS TIPPING RESTRAINT TO ATTACH THIS UNIT TO THE WALL, TO PREVENT ACCIDENTS AND/OR INJURIES. THIS HARDWARE MUST PROPERLY INSTALLED (FOLLOW DIRECTIONS IN ORDER ON THIS INSTRUCTIONS), TO PROVIDE PROTECTION AGAINST THE UNEXPECTED TIPPING OF FURNITURE DUE TO IMPROPER USE.
Page 4
Parts and Hardware List Please read completely through the instructions and verify that all listed parts and hardware are present before beginning assembly. A- File Cabinet (Qty. 1) (Qty. 2) (Qty. 2) Left Front / Right Back Leg Right Front / Left Back Leg (Qty.
DRAWER INSTALLATION If you need to remove the drawers with ball bearing slides from the unit, please follow the steps below to prevent any damage to the slides or the drawers. Release leveler 1. If you need to remove the drawer, please pull the drawer all the way out, then simultaneously pushes the plastic release lever of the ball bearing slide up on one side and down on the other side, and then pull the drawer completely out.
Page 6
Assembly Instructions NOTE: Please do not fully tighten all bolts until you finish assembling all parts. Once assembled, go back and fully tighten all bolts. This will make the assembly easier. 1. Unpack the unit and confirm that you have all the hardware and required parts. Assemble the unit on a carpeted floor or the empty carton to avoid any scratch.
Page 7
Assembly Instructions 3. Ask for assistance to lift the assembled unit upright. 4. Position the Guide Rails (D) onto the drawer sides with the high side facing inward. 5. Hook four Guide Blocks (E) onto the high edge of Guide Rails (D). Now set the File Hangers (F) into the slot of Guide Blocks (E).
Page 8
Assembly Instructions Wooden stud Wall Short screw Wall Metal bracket Metal bracket Nylon strap Long screw Floor leveler Tools required (not provided): Phillips screwdriver, stud finder, tape measure, pencil, power drill and 1/8” drill bit. 7. Position the unit at the desired location against a wall. If necessary, adjust the Floor Levelers at the bottom of the Legs (B and C) to level the unit.
Care and Maintenance ⚫ Use a soft, clean cloth that will not scratch the surface when dusting. ⚫ Gently rub the surface with a soft dry cloth, soft damp cloth, or soft damp cloth with neutral detergent, and then dry it well. ⚫...
Need help?
Do you have a question about the Whitney Lateral File SPLS-WHLF-TV and is the answer not in the manual?
Questions and answers