Page 2
M A X I M U M R E C O M M E N D E D W E I G H T L O A D S MANUFACTURER: Whalen Furniture Manufacturing CATALOG: Breslyn Drawer File MODEL # SPLS-BRDF-TV MAXIMUM LOAD 22.7 kg / 50 lb MAXIMUM LOAD 9.1 kg / 20 lb THIS UNIT IS INTENDED ONLY FOR USE WITHIN THE MAXIMUM...
Page 3
FURNITURE TIPPING RESTRAINT YOUNG CHILDREN MAY BE INJURED BY TIPPING FURNITURE AND YOU MUST USE THIS TIPPING RESTRAINT TO ATTACH THIS UNIT TO THE WALL, TO PREVENT ACCIDENTS AND/OR INJURIES. THIS HARDWARE MUST PROPERLY INSTALLED (FOLLOW DIRECTIONS IN ORDER ON THIS INSTRUCTIONS), TO PROVIDE PROTECTION AGAINST THE UNEXPECTED TIPPING OF FURNITURE DUE TO IMPROPER USE.
Page 4
Parts and Hardware List Please read completely through the instructions and verify that all listed parts and hardware are present before beginning assembly. A- File (Qty. 1) (Qty. 2) (Qty. 4 ) (Qty. 2 ) Guide Rail Guide Block File Hanger Tipping Restraint Hardware Kit (Qty.
Page 5
DRAWER INSTALLATION If you need to remove the drawers with ball bearing slides from the unit, please follow the steps below to prevent any damage to the slides or the drawers. Release lever 1. If you need to remove the drawer, please pull the drawer all the way out, then simultaneously pushes the plastic release lever of the ball bearing slide up on one side and down on the other side, and then pull the drawer completely out.
Page 6
Assembly Instructions 1. Unpack the unit and confirm that you have all the hardware and required parts. 2. The file comes with the handle pre-assembled to the inside of utility drawer. To remove the handle, unscrew the bolts located on the front of the drawer. Re-install the handle to the front of the utility drawer with the same bolts.
Page 7
Assembly Instructions Wooden stud Wall Nylon strap Short screw Wall Floor leveler Metal bracket Long screw Tools required (not provided): Phillips screwdriver, stud finder, tape measure, pencil, power drill and 1/8” drill bit. 5. Position the unit at the desired location against a wall. If necessary, adjust the floor levelers at the bottom of the legs to level the unit.
Page 8
Care and Maintenance Use a soft, clean cloth that will not scratch the surface when dusting. Gently rub the surface with a soft dry cloth, soft damp cloth, or soft damp cloth with neutral detergent, and then dry it well. ...
Need help?
Do you have a question about the Breslyn SPLS-BRDF-TV and is the answer not in the manual?
Questions and answers