Memory Upgrade Module; Installing A Memory Upgrade Module - Fujitsu LifeBook B-2130 User Manual

Memory Upgrade
Module
Your Fujitsu LifeBook notebook may be configured with
up to 192MB maximum high speed Synchronous
Dynamic RAM (SDRAM) factory installed. To increase
your notebook's memory capacity, you can replace the
original memory module with a higher capacity module.
The memory upgrade must be a dual-in-line (DIMM)
SDRAM module, however it can be any capacity.
C A U T I O N
Do not remove any screws from the memory upgrade
module compartment, except the ones specifically
shown in the directions for installing and removing
the memory upgrade module.

INSTALLING A MEMORY UPGRADE MODULE

1. Turn off power to your notebook using the power
switch, and remove any power adapter
(AC or auto/airline).
2. Make sure that all the connector covers are closed.
3. Turn the notebook bottom side up, with the front
panel toward you.
4. Remove the screws of the memory upgrade module
compartment. (Figure 4-5)
5. Remove the cover.
Figure 4-5 Opening the Memory Upgrade Compartment
U s e r I n s t a l l a b l e F e a t u r e s
C A U T I O N
The memory upgrade module can be severely damaged
by electro-static discharge (ESD). Be sure you are prop-
erly grounded when handling and installing the module.
6. Remove the memory upgrade module from the
static guarded sleeve.
7. Align the memory upgrade module with the part
side up. Align the connector edge of the memory
upgrade module with the connector slot in the
compartment. The connector will be pointing
toward the rear of the notebook.
8. Insert the memory upgrade module at a 45° angle.
Press the connector edge of the module firmly down
and into the connector until it lodges under the
retaining clip. You will hear a click when it is prop-
erly in place. (Figure 4-6)
Figure 4-6 Installing a Memory Upgrade Module
9. Replace the cover.
10. Replace the screws.
P O I N T
The memory upgrade module is not something you
routinely remove from your notebook. Once it is
installed, you can leave it in place unless you want
to change system memory capacity.
47