Preparation Before Operation - Mitsubishi Electric Mr.Slim MS-GK36VA Operating Instructions Manual

Table of Contents

Advertisement

Available languages

Available languages

● OPERATING INSTRUCTIONS ●
N
AME OF EACH PART
Indoor unit
Air cleaning fi lter
(Anti-Allergy Enzyme Filter)
Air fi lter
(Catechin air fi lter)
Air inlet
Air outlet
Horizontal vane
Outdoor unit
Outdoor units may be different in appearance.
P
REPARATION BEFORE OPERATION
Before operation: Insert the power supply plug into the power outlet and/or turn the breaker on.
Installing the remote controller batteries
4.
Press RESET.
1.
Remove the front lid.
• Make sure the polarity of the batteries is correct.
• Do not use manganese batteries and leaking batteries. The remote controller
could malfunction.
• Do not use rechargeable batteries.
• Replace all batteries with new ones of the same type.
• Batteries can be used for approximately 1 year. However, batteries with
expired shelf lives last shorter.
• Press RESET gently using a thin instrument.
If the RESET button is not pressed, the remote controller may not operate
correctly.
En-3
Front panel
Emergency
operation
switch
Page 4
Display section
Operation indicator
lamp
Remote control
receiving section
Air inlet (back and side)
Refrigerant piping
Drainage hose
Air outlet
Drain outlet
2.
Insert the negative
pole of AAA alkaline
batteries fi rst.
3.
Install the front lid.
Remote controller
Operation display
section
OFF/ON
(stop/operate)
button
FAN speed
control button
Page 5
Operation
select button
Page 4
ECONO
COOL
button
Page 6
VANE
control button
Page 5
LONG
button
Page 6
Only use the remote controller provided with the unit.
Do not use other remote controllers.
If two or more indoor units are installed in proximity to one another, an indoor
unit that is not intended to be operated may respond to the remote controller.
Setting current time
1.
Press CLOCK.
3.
Press CLOCK again.
• Press CLOCK gently using a thin instrument.
Signal transmitting
section
Distance of signal :
About 6 m
Beep(s) is (are) heard
from the indoor unit when
the signal is received.
Temperature buttons
Page 4
Off-timer button
Page 6
On-timer button
Page 6
WIDE VANE button
Page 5
TIME set buttons
Page 3, 6
Increase time
Decrease time
CLOCK button
Page 3
RESET button
Page 3
Lid
Slide down to open
Remote controller
holder
• Install the remote control-
ler holder in a place where
the signal can be received
by the indoor unit.
2.
Press the TIME buttons to set
the time.
Each press increases/decreases
the time by 1 minute (10 minutes
when pressed longer).

Advertisement

Table of Contents
loading

Table of Contents