Table of Contents
Advertisement
COMMUNICATION
▷
All international calls.
1.
"Incoming calls"
2.
"Ok"
3.
"All calls", "Int'l calls"
4.
"Ok"
5.
"Activate", "Deactivate" or "Status"
6.
Enter your password.
7.
"Ok"
Deactivating call barring
1.
"Deactivate all"
2.
Enter the password and confirm with "Ok".
Resetting settings
All snap-in adapter settings are reset to factory
settings. The WLAN will need to be re-config‐
ured and the Bluetooth connections re-estab‐
lished.
/
Press the buttons simultane‐
ously.
Wi-Fi hotspot in the rear
Principle
A device such as a WLAN-capable notebook can
be wirelessly connected to the snap-in adapter
via the WLAN.
Operating requirements
▷
The SIM card has been inserted into the
snap-in adapter and the snap-in adapter is
ready for operation.
▷
The device is on and ready for operation.
▷
The WLAN connection on the device is
switched on.
▷
The access data of the service provider is
known: APN, user name, password.
The APN, or the access point of the service
provider, will change when you switch to an‐
82
Rear telephone
Online Edition for Part no. 01405A1E094 - X/20
other mobile telephone network, for example
abroad. Please ask the service provider about
which APN to use for other mobile telephone
networks.
▷
The WPA2 key and the name of the snap-in
adapter, SSID, are available. The information
can be found on the back of the snap-in
adapter.
Connecting the device to the
snap-in adapter
1.
Check whether the bottom LED
above the WLAN button flashes green.
If the LED does not flash green:
Press the button on the snap-in adapter for
approximately 5 seconds until the bottom
LED above the WLAN button flashes green.
2.
On the device, start the program for setting
up wireless networks, see the device's oper‐
ating instructions.
3.
Select "BMW Wireless" from the list of wire‐
less networks within range of the snap-in
adapter and connect.
4.
Enter the WPA2 key.
The bottom LED above the WLAN button on
the snap-in adapter is illuminated green if a
connection has been established.
Configuring the connection to
the Internet
To establish a connection to the Internet you
need to configure the snap-in adapter.
1.
Start the Internet browser on the device.
2.
Enter the following URL in the Internet
browser's URL bar: http://192.168.1.1
The CON-SIA2 page is displayed.
3.
Select "WAN".
4.
If the fields are still blank, enter the data. The
data is provided by the service provider.
"APN": access point of the service provider.
Hide quick links:
Advertisement
Table of Contents
