Memory Expansion; Installing And Removing The Memory Extension - Fujitsu Siemens Computers CELSIUS Mobile H210 Operating Manual

Memory expansion

Your notebook has 256 Mbyte - 2 Gbyte of main memory installed, depending on the upgrade level.
The notebook will not start without memory modules, as no fixed main memory is installed.

Installing and removing the memory extension

Please note the information provided in the "Notes on installing and removing boards and
!
modules" section in the "Important notes" chapter.
The notebook must be switched off when installing/removing the memory modules, it
must not be in Suspend mode.
Use only memory extensions of the manufacturer which have been approved for your
notebook (256, 512 Mbyte modules or 1 Gbyte modules of the type DDR333 SDRAM).
Never use force when installing or removing memory modules.
Make sure that foreign objects do not fall into the memory module compartment.
The memory modules are located in a larger service compartment. You must open the
i
entire service compartment when removing and installing a memory module. Once you
have removed the cover, the various components are exposed. These components should
be removed and replaced only by authorised specialists.
► Switch the notebook off.
► Close the LCD screen so that it locks into place.
► Unplug the power adapter from the mains outlet.
► Disconnect all cables connected to the notebook.
► Place the notebook upside down on a flat surface.
► Remove the battery (see "Removing battery").
A26391-K154-Z120-1-7619, Edition 2 75