Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Microhard Systems MHX2421
Summary of Contents for Microhard Systems MHX2421
- Page 1 Operating Manual MHX2421 2400 MHz Spread Spectrum OEM Transceiver Revision 0.30 March 5, 2007 Model: MHX2421 Microhard Systems Inc. #17, 2135 – 32 Ave N.E. Calgary, Alberta T3K 4Z4 Phone: (403) 248-0028 Fax: (403) 248-2762 www.microhardcorp.com...
-
Page 2: Warranty
Warranty Microhard Systems Inc. warrants that each product will be free of defects in material and workmanship for a period of one (1) year for its products. The warranty commences on the date the product is shipped by Microhard Systems Inc. Microhard Systems Inc.’s sole liability and responsibility under this warranty is to repair or replace any product which is returned to it by the Buyer... -
Page 3: Mhx2421 Regulatory Requirements
WARNING: Changes or modifications not expressly approved by Microhard Systems Inc. could void the user’s authority to operate the equipment. This device has been tested with MCX and Reverse Polarity SMA connectors with the antennas listed in Appendix A When integrated in OEM products, fixed antennas require installation preventing end-users from replacing them with non-approved antennas. -
Page 4: Table Of Contents
Contents Warranty ..................................ii Warranty Diclaims................................ ii Indemnification................................ii Proprietary Rights................................. ii MHX2421 Regulatory Requirements .......................... iii CONTENTS ................................IV GENERAL ................................1 ................................ 1 RODUCT VERVIEW ..............................2 UTPUT OWER EVEL INSTALLATION..............................4 ..................................4 VERVIEW ............................4 STIMATING THE ARGIN .............................. -
Page 5: General
The small-size and superior RF performance of this module make it ideal for many applications. While a pair of MHX2421 modules can link two terminal devices (“point- to-point” operation); multiple modules can be used together to create a network of various topologies, including “point-to-multipoint”... -
Page 6: Output Power Level
While the typical application for the MHX2421 is to provide a short- to mid-range wireless communications link between DTEs, it can be adapted to almost any situation where an asynchronous serial interface is used and data intercommunication is required. - Page 7 MHX2421 Operating Manual: Chapter2 General...
-
Page 8: Installation
Qualified and experienced personnel must carry out the installation, removal or maintenance of all antenna components. The MHX2421 complies with FCC part 15 at the modular level for operation in the license-free 2400-2483.5 MHz ISM band. This chapter provides guidelines for installing and deploying equipment which incorporates the MHX2421 module. - Page 9 Figure 1 Gain Calculation The power level has been set to 30dBm (1W) on the transmitter, and the receiver sensitivity for the MHX2421 is -108dBm. System gain would be calculated to be: 30 - 2 + 6 + 3 - 2 + 108 = 143 dB.
-
Page 10: Antennas And Cabling
-95dBm. 3.2 Antennas and Cabling This section describes the recommended procedure for installing cabling and antennas for use with the MHX2421 module. 3.2.1 Internal Cabling The most common method for installing the module is to run a cable from the module’s MCX connector to a reverse TNC bulkhead connector on the... -
Page 11: Installing External Cables, Antennas And Lightning Arrestors
Typically, both ports on surge arrestors are N-female. External Filter WARNING: Although the MHX2421 is capable of filtering out RF noise in most Direct human contact with the environments, there are circumstances that require external filtering. antenna is potentially unhealthy... - Page 12 See appendix A for a list of approved antennas that can be used with The MHX2421 can only be used the MHX2421 radio modem. If you require another type of antenna with any antennas listed in please contact Microhard Systems Inc. The MHX2421 CANNOT be Appendix A.
- Page 13 36dBm with respect to the isotropic radiator. Example 1) What is the maximum power the MHX2421 can be set to comply with FCC and IC given the following equipment given a Rubber Ducky Ant Gain 2dBi and no cable or connectors in the system? Max EIRP 36dBm Max TX power = EIRP –...
- Page 14 15 dBi, 2.4GHz Omni Directional Antenna RPTNC Pigtail WARNING: Changes or modifications not expressly approved by Microhard Systems Inc. could void the user’s authority to operate the equipment. This device has been tested with MCX and Reverse Polarity SMA connectors with the antennas listed in Appendix A When integrated in OEM products, fixed antennas require installation preventing end-users from replacing them with non-approved antennas.
Need help?
Do you have a question about the MHX2421 and is the answer not in the manual?
Questions and answers