Fujitsu 690Tx User Manual page 151

Symptom
The CD-ROM Access indicator on the Status
Indicator panel blinks at regular intervals when
no CD is in the tray or the CD-ROM drive is
not installed.
T r o u b l e s h o o t i n g
Possible Cause
5. Setup utility is set to something other
than auto or CD-ROM for the Secondary
Master Controller.
6. Wrong drive designator was used for
CD-ROM in the application.
7. Windows CD auto insertion function
is disabled.
8. Notebook is not properly installed in
an Enhancement Unit.
1. The Windows CD auto insertion function
is active and is checking to see if a CD
is ready to run.
L i f e B o o k 6 0 0 S e r i e s f r o m F u j i t s u
Possible Solution
5. Revise BIOS settings to set the Secondary
Master correctly. (See Main menu and
Secondary Master submenu pages 61-66 for
more information.)
6. Verify the drive designator used by the
application is the same as the one used by
the operating system. When the operating
system is booted from a CD-ROM drive
designations are automatically adjusted.
(See page 66.)
7. Start the CD from the desktop or
application software or re-enable the
Windows CD auto insertion function.
(See page 25.)
8. Remove and re-install your notebook in the
Enhancement Unit.
1. This is normal.
You can disable this function if you wish.
(See CD-ROM Access Indicator on pages 25-
26 for more information.)
141