Fujitsu 690Tx User Manual page 156

S e c t i o n F i v e
Symptom
PC Card Problems
A card inserted in the PC Card slot does not
work or is locking up the system.
Power Failures
You turn on your notebook and nothing
seems to happen.
146
Possible Cause
1. The card is not properly installed.
2. The card may have been installed with an
application running and your notebook
doesn't know it's there.
3. Your software may not have the correct
software driver active.
4. You may have the wrong I/O address selected
for your PC Card device.
5. Your PC Card device and another device are
assigned the same I/O address.
1. The internal battery is completely discharged,
there is no external battery installed and
there is no power adapter (AC or auto/
airline) installed.
Possible Solution
1. Remove and re-install the card.
(See PC Cards on pages 108-111.)
2. Close your application and restart
your notebook.
3. See your software documentation and
activate the correct driver.
4. See your PC Card documentation to
determine the required I/O address.
5. Check all I/O addresses in the BIOS setup
utility and your other installed hardware
and make sure there are no duplications.
1. When all the batteries are dead there will
be a beep when the power switch is turned
on and the notebook will immediately go
into Dead Battery Suspend mode. (See pages
31-32.) Check the Status Indicator panel to
determine the presence and condition of
the batteries. (See pages 24-25.) Install the
external battery if it is not installed or a
power adapter if all batteries are dead or
unavailable. (See pages 107-108 and 14-15.)