Preparation; Assembly Instructions - LF UTILETECH CYWE08-7 Manual

Before beginning assembly of product, make sure all parts are present. Compare parts with package
contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 5 minutes

ASSEMBLY INSTRUCTIONS

CAUTION:DO NOT OPERATE THIS HEATER WITHOUT CASTORS ATTACHED
NOTE: It is normal for the oil to move inside the radiator when moving the product.
1
1. Place the unit upside down on a flat, stable surface, ensuring it will not tip over.
2. Front castor assembly installation: Remove the wing nuts from the U-bolts.
Attach the castor assembly under the front cover then secure the castor assembly with
wing nuts to the U-bolt (refer to step 2-3).
3. Rear castor assembly installation: attach the U-bolt between the rear two fins then secure
the castor assembly with wing nuts to the U-bolt (refer to step 2-3).
NOTICE: Do not over-tighten the wing nuts.
4. Put the unit on flat surface and ensure that it can move freely and smoothly (refer to step 4).
5. Set the unit upright and wait at least three minutes for the oil to settle before turning on.
2
3
4
4