Anchor Plate With Length (Apl) - M&G DuraVent DuraStack PRO DCL Installation And Maintenance Instructions Manual

ANCHOR PLATE WITH LENGTH (APL)

The APL is an anchor plate integrated on a length. It cannot be used as a fixed support
for vertical or horizontal installation because the anchor plate is free to move on the
longitudinal axis of the length. Refer to the Anchor Plate (AP) for all the warnings /
details, except for the installation. See Figure 43 for detail of APL.
For the Models DCL, DIS PRO and DAS PRO, no outer wall is supplied. It is the Outer
Band (BSE) that serves as the outer wall.
CAUTION: Small brackets must be on the bottom side so these can hold the
outer band (BSE) against the support plates and to make sure the anchor plate
is positioned in the middle of the inner wall when installed. See Figure 43 to 46.
Figure 43 - Anchor Plate with Length (APL)
WARNING:
Risk of fire - do not attach the plate support to
combustable construction
Figure 44 - Step 1 of installation of APL
Vent Section
Outer Band (BSE)
uninstaled yet
Inner V-Band
(BSI)
Removable Alignment
Sleeve
Anchor Plate
with Length (APL)
Alignment Sleeve
Inner V-Band
(BSI)
Outer Band (BSE)
uninstalled yet
Vent Section
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
*The framework
has been cut for
a better view of
the assembly
Figure 45 - Step 2 of installation of APL
Figure 46 - Step 3 of installation of APL
Vent Section
Outer Band (BSE)
uninstalled yet
Inner V-Band
(BSI)
Anchor Plate
with Length (APL)
Half Framework
Inner V-Band
(BSI)
Outer Band (BSE)
uninstalled yet
Vent Section
21