Fig.4 Temperature Sensor Inside The Cabinet; Fig.5 Exchange Of Fl Uorescent Lamps; Fig.6 Cleaning Of The Condenser - Igloo ELBA User Manual

2
1
It is essential to keep the condenser of the device
clean. Dirt may hinder the heat exchange, causing
mainly increase in electric energy consumption
and may cause damage of aggregate compressor.
In cabinets with upper aggregate it is recommended
to clean the condenser at least once a year. Clean
condenser lamellas with help of soft brush or paint-
brush. If the condenser is extremely dirty (blocked
lamellas) it is indicated to use vacuum cleaner or
compressed nitrogen to suck / blow the dirt from
between lamellas.
The producer shall not be held responsible for damages of the condenser aggregate resulting from
non-observance of condenser cleanliness!
Door seal should be cleaned only with clean water, without addition of washing agents, and it should be
thoroughly dried. The seal cannot come in contact with greasy substances or oils!
During maintenance services it is necessary to check whether doors close in a proper manner.
Test: place a sheet of paper between the seal and the casing and close the door. The paper should
pose felt resistance during an attempt of pulling it out.
During maintenance services it is necessary to pay attention not to damage the data plate of the device Fig.7
(p.15), which contains signifi cant information for servicing organs and waste removal companies.
www.igloo.pl
When using the unit as well as during maintenance work,
be careful not to damage the temperature sensor!
Do not use mechanical agents to fasten the defrosting
process!
1 3 4
3
2
3
10
9
4 5
8
Fig.5 Exchange of the fl uorescent lamps
1 – Lifted advertisement panel (colourless)
2 – Plexi plate of the upper panel
3 – Grips fi xing the Plexi plate
4 – Grip of the fl uorescent lamp (illumination of the upper panel)
5 – Fluorescent lamp
6 – Casing of the fl uorescent lamp and the starter
7 – Starter of the fl uorescent lamp
8 – Casing of the fl uorescent lamp
9 – Transparent casing of the fl uorescent lamp (internal illumi-
nation)
10 – Metal casing of the fl uorescent lamp (internal illumination)
Fig.6 Cleaning the condenser
en
7 6
13
User manual Elba