Load Sensing - Sensor Logic; Switching Off The Dishwasher; Emptying The Dishwasher - AEG FAVORIT 40740 User Instructions

Changing the wash programme after the start delay has been set:
As long as the wash programme has not yet started, you are able to
change the programme set by pressing a wash programme button.
1. Press the button for the new wash programme and hold it down.
0
First, the indicator for the wash programme that was already selected
will flash.
After several seconds only the indicator for the new wash programme
will be illuminated.
2. Release the programme button.
The wash programme will start automatically following a countdown
of the hours set.
Load Sensing – Sensor Logic
If a wash programme is started even though there are only a few dishes
in the upper and/or lower basket, an intelligent electronic system
adjusts the amount of water and the duration of the wash programme
to the number of dishes. By this means it is possible to wash only a few
dishes quickly and economically. At half load (6 place settings), up to
2 litres of water and 0.2 kWh of electricity are saved.

Switching Off the Dishwasher

Switch off the dishwasher when
progress display.
1. Press the ON/OFF button.
0
The ON/OFF button indicator extinguishes.
Hot steam may escape from the appliance when opening the door
1
immediately after the end of the programme.
2. Open the door carefully.

Emptying the Dishwasher

• The dishes should therefore be allowed to cool down before removing
3
them from the appliance, as hot dishes may be sensitive to knocks.
• Leave the dishes in the dishwasher for approx. 15 minutes after the
end of the programme so that they dry better and can cool down.
• First empty the lower basket, and then the upper basket. This will
avoid any water that may be remaining in the upper basket, dripping
onto the dishes in the lower basket and leaving water marks.
L
is illuminated on the programme
Operating Instructions
29