Safety Information - Textron HDE HI-TEST IT-4 Operating Instructions Manual

SAFETY INFORMATION

Hi-Test Detection Instruments is now a part of HD Electric Company.
HD Electric Company, located in Waukegan, Illinois, USA is a manufacturer and provider
of a wide range of electrical equipment.
At HD Electric Company, we understand the special training and requirements for work
on electrical power distribution systems. Please take a few moments to read this manual
in its entirety before using your new equipment. Pay special attention to the warnings
and cautions both in this manual and on the equipment itself.
NOTICE - This product is designed for use by professionals trained in its use and
application in and around high voltage electrical equipment. If you are not trained in
the work methods required for safe operation, do not proceed until you obtain training.
CAUTION - This product was tested before leaving the factory but it must be tested
prior to and after each use for proper working operation. Be aware that dirt, moisture,
mechanical fatigue and other factors reduce the dielectric strength of this product.
If any defect of condition is noted, do not use this product. Remove from service and
arrange for repair.
WARNINGS - Rigorous hot stick work precautions and OSHA and company work
practices must be followed. Always wear approved cover-up and safety equipment.
Read and understand instructions prior to use. Misuse or abuse of this product can
lead to severe injury or death.
OPERATIONAL IMPAIRMENT - If the IT-4 is used in a manner not described in this
instruction manual, the protection and effective operation of this equipment may
be impaired.
CLEANING INSTRUCTIONS - To clean the IT-4 wipe with a damp cloth with water.
Do not use harsh chemicals or solvents.
3