Advertisement
Quick Links
Please read the instructions completely before beginning the installation.
Edo Collection
Model Number: 9229ED-TM
Flush both supply lines before installation, then shut off both supply lines.
Minimum hole size for the spout and handle trim is 1-1/4" and maximum of 1-1/2"
ROUGH INSTALLATION
- Determine where the finished wall will be. This measurement is
1
necessary to accurately plumb in the valve.
- Install the valve making sure that the measurement between the
center of the valve inlet and the outside of the finish wall is 2-3/4". This
measurement is called the backset.
- Using 1/2" IPS, connect the corner of the valves to the spout
2
base at the desired spread.
- Again, allow no more than 1-1/4" diameter holes for the spout and
handles.
NOTE:
- Where tile construction is planned for the finished walls, allow for
extra thickness dimensions when roughing in the valves.
- Test for proper function before closing walls.
The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
Wall Mount Widespread Lavatory Set
Edo Crystal Collection
Model Number: 9229DC-TM
Center of Valve Inlet
Rev 06/2016
Installation Instruction
EDO COLLECTIONS
Backset
Finished Wall
1/6
Advertisement
Related Manuals for Santec EDO 9229ED-TM
Summary of Contents for Santec EDO 9229ED-TM
- Page 1 Rev 06/2016 Installation Instruction EDO COLLECTIONS Wall Mount Widespread Lavatory Set Please read the instructions completely before beginning the installation. Edo Collection Edo Crystal Collection Model Number: 9229ED-TM Model Number: 9229DC-TM Flush both supply lines before installation, then shut off both supply lines. Minimum hole size for the spout and handle trim is 1-1/4”...
-
Page 2: Spout Installation
SPOUT INSTALLATION - Wrap the pipe threading for the spout with teflon tape. Then, thread the spout onto the pipe until it is secured with the spout facing downward. NOTE: The length of threaded pipe coming out from the finish wall should be no longer than 1/2”. -
Page 3: Parts Drawing
PARTS DRAWING PART DESCRIPTION PART # Wall Mount Widespread Spout PS-6ED00-U Aerator Rubber Washer PM-510 Aerator PM-320 Aerator Housing P0961 Complete ED Handle YY-ED Flange Washer PM000 * Please specify the finish when ordering the part. The measurements shown are for reference only. Products and specifications shown are subject to change without notice. www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681... -
Page 4: Specification Sheet
SPECIFICATION SHEET POP-UP Ø 2 " " " 12" Ø 1 " The measurements shown are for reference only. Products and specifications shown are subject to change without notice. www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681... -
Page 5: To Obtain Warranty Service
Doing so may ruin your faucet finish and/or void the warranty. Thank you for making SANTEC a part of your lifestyle and luxury spa experience. Our products have been created as works of enduring quality and sophisticated design. -
Page 6: Lifetime Limited Warranty
SANTEC reserves the product components of the covered product will be repaired, refinished, or replaced at the sole discretion of SANTEC. SANTEC reserves the right to examine any product claimed defective prior to any warranty claim being accepted or processed, at its sole discretion. This warranty gives you specific legal rights and you may have other rights which may vary from state to state.