JABSCO 18670 Series Installation And Operating Instructions

COMMERCIAL DUTY
WATER PUPPY
FEATURES
Body:
Bronze
Impeller:
Jabsco Nitrile compound
Seal:
Lip Type
Ports:
1/2" Internal Pipe Threads
1" External Hose Barb
Adapter for 3/4" External Garden
Hose Thread included
Motor:
Permanent magnet type, fully enclosed,
stainless steel shaft, ball type shaft
bearing, has adequate torque to
reverse the pump
Dimensions: 3" (76mm) high, 6-7/8" (175mm) long,
4-3/4" (120mm) wide
Weight:
6 lb (2.7 kg)
Motor meets USCG Electrical Standard 183.410 and ISO
8846 MARINE for IGNITION PROTECTION on gasoline
powered vessels.
WARNING
!
Explosion Hazard. Do not pump gasoline, solvents, thinners
or other flammable liquids. To do so can cause an explosion
resulting in injury or death.
WARNING
!
Explosion Hazard. Do not operate with rivets removed from
motor case. Explosion resulting in personal injury, death or
property damage can occur. Case openings must be sealed
to avoid explosion and maintain ignition protected rating.
APPLICATION
Use for bilge pumping, livewell circulation, washdown
and general pumping requirements. For intermittent duty,
motor may be reversed to empty bait tank.
Pump has a dry prime suction lift of about 6 feet (2m) and
a lift to 20 feet (6m) when primed. BE SURE SUCTION
LINES ARE AIRTIGHT.
INSTALLATION
The pump must be mounted in a dry location—the motor
is not waterproof and must not be submerged.
SELECTION OF A COOL VENTILATED location will gen-
erally extend pump motor life. The unit can be mounted in
any desired position. It is best to mount so that water
dripping from loose port connection will not wet the
motor. The pump head may be rotated 180° on the motor
to change the direction of flow.
Model 18670-Series
Model
18670-0123
18670-0923
18670-0943
PLUMBING CONNECTIONS
Pump ports have external 1" hose barb and internal 1/2"
pipe threads. Also provided are two male port adapters
to allow the attachment of 3/4" female garden hose
fittings. Use hose that does not kink when bent and with
sufficient wall thickness to prevent collapse when used
on suction side of pump. Hoses should be routed so that
some water will be retained in pump body to wet the
impeller. Wetting the impeller aids in priming and
extends impeller life. Use a strainer on the intake hose to
stop trash and solids from going through the pump. All
hoses must have airtight connections to enable faster
priming.
Total Head
PSI Feet Meters
2.1 5
4.3 10
6.5 15
8.7 20
Table shows approximate Head-Flow for new pump.
Voltage
12 Vdc
12 Vdc
24 Vdc
Capacity
GPM LPM
1.5 9
3.0 8.4
4.6 7.7
6.1 6.9
34.1
31.8
29.1
26.1