Tripp Lite B051-000-AC Quick Start Manual page 8

Administrator Setup
Network Setup — IP Address Determination
IP Installer
The CD that comes with the product includes a Windows-based IP
Installer utility that can be used to obtain and edit the IP address.
To use the IP Installer utility, the computer you are using must be
running a Windows operating system, and must be on the same
network as the IP remote access unit. Also, the IP Installer setting
in the Admin Utility must be set to Enabled, which it is by default.
(See the ANMS section in the Owner's Manual for details.)
1. Save the IP Installer utility file to a desired location on your
computer. Double-click on the file to open the IP Installer utility.
12-176 93-3159_RevC.indd 8
continued
(continued)
2. Select the B051-000-AC from the Device List. Note: If the list
is empty, or your device doesn't appear, click the Enumerate
button to refresh the Device List. If there is more than one device
in the list, use the MAC address on the bottom of your unit to
determine the desired device.
3. To assign a fixed IP address, check the Specify an IP address
checkbox and fill in the IP Address, Subnet Mask and Default
Gateway fields with information appropriate for your network.
4. Click the Set IP button to apply the changes to the unit. The new
IP address will appear in the Device List.
5. Click the Exit button to exit the IP Installer utility.
8
8/27/2012 2:48:19 PM