Marlec HRDi Remote Display User Manual

Marlec Engineering Co Ltd
Fascia size:
Panel cut out:
Check you have received:
1 x HRDi Remote Display
1 x 3m Data Cable
You will need:
Suitable screws to affix the display to the chosen surface.
For use with the Marlec HRDi Controller to enable remote viewing of the display and temporary shutdown of
the Rutland Windcharger and solar panels connected.

Installation

Locate a suitable position within the panel & cut out the specified aperture.
Feed the data cable through the cut out & route through to the HRDi. (Use only the cable
supplied).
Plug the data cable in to the data socket on the HRDi.
Plug the data cable into the remote display unit.
The remote display unit will display some messages on the screen while it tests the data
link & synchronizes with the HRDi. When complete, the display will mimic the HRDi display.
If the remote display shows any error messages then check that the data cable is
connected at both ends & the HRDi is connected to the batteries & displaying normally.
Fit the unit into the panel & secure the fascia via the 4 x fixing holes using suitable screws.
Doc No: SM-349 Iss A 11.02.13
HRDi Remote Display
User Manual
135mm x 80mm
125mm x 60mm Depth behind panel: 25mm
HRDi Remote Display Manual