Table of Contents
Advertisement
Cleaning
en
The volume of the audible signal at
5.
the end of the program is shown in
the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Finish in" time button or
6.
the drying time button to change the
volume.
Turn the program selector clockwise
7.
to position 4.
The volume for the audible button
8.
signal is shown in the display.
0 = off, 1 = quiet, 2 = medium,
3 = loud, 4 = very loud
Press the "Finish in" time button or
9.
the drying time button to change the
volume.
Exiting setting mode
Turn the program selector to the "Off"
position once you have set the required
spin speed and the volume. The
settings have now been saved.
30
D
Cleaning
C leaning the dryer and the
C l e a n i n g
control panel
:
Warning
Risk of death!
There is a risk of electric shock as the
dryer is operated with electricity.
Disconnect the dryer from the mains
before cleaning.
Clean the dryer using only water and a
soft, damp cloth.
Remove all detergent residue, spray
residue or other residues immediately.
Do not use cleaning agents or agents
for pre-treating laundry (e.g. prewash
sprays, stain removers). Do not use
high-pressure cleaners or steam jet
cleaners to clean your appliance.
Cleaning the heat exchanger
Notes
The heat exchanger requires
■
cleaning once a month, however this
varies depending on how frequently
the dryer is used.
If there is debris in the heat
■
exchanger, this will increase the
amount of time required for drying
and will compromise the drying
results.
Allow the dryer to cool down and
1.
place an absorbent cloth beneath
the maintenance flap.
Residual water may leak out.
Note:
Open the maintenance flap fully.
2.
Advertisement
Table of Contents
