Table of Contents
Advertisement
Programs and buttons
en
Buttons
Buttons
Default Program and Option settings
Note:
At the factory initial settings are pre-set for all cycles. You can change some program settings as fol-
lows.
Fine adjust
Time Dry
Finished in
Additional Program Option settings
Less Ironing
Low Heat
Other buttons
Signal
22
Explanations and notes
The dryeness level can be increased in 3 steps )i.e. the laundry is drier) by touching
the Dry level button for certain programs.
Default setting = 0 (No LED Symbol shown)
Selectable values: 0, +1, +2, +3
After the dryness level for a program is set, it is retained until changed again.
Available only for Time programs, ~ Page 20 can be selected from minimum 20
minutes to maximum 3 hours, in 10-minute steps.
The program end (Finish in) time can be set in one hour increments to a maximum of
24 h (hours).
After selecting the desired drying program (at the dial) but before touching the Start
button, touch the Finish in button until the desired time is displayed, e.g. 8 h, then
touch the Start button to start the dryer.
The cycle duration is included in the set Finish in time.
Note:
8 h is displayed (until Energy-Saving mode activates) and counts down (approxi-
mately 5hr:30min) until the drying cycle begins (at 2hrs:30min) then the cycle dura-
tion 2:30 is displayed and drying begins. Total time approximately 8 hours.
To prevent the laundry from creasing or wrinkling, the dryer drum rotates at specific
intervals following the drying process.
If the Wrinkle Block button is touched, this function is set to 60 (+60) or 90 (+90)
minutes.
The laundry remains loose and fluffy until it is removed.
The laundry should be removed before this time has elapsed.
Reduced temperature for delicate fabrics, e.g. polyacrylic, polyamide or elastane,
with longer drying time.
Observe the care information or symbols on the textile's label.
A signal sounds after the program has ended ~ Page 29
Advertisement
Table of Contents
