Table of Contents
Advertisement
40
To Change the Lamp
1
Turn off the projector by pressing the power button.
2
Allow the projector at least 30 mins to cool down.
3
Disconnect the power cord.
4
Open the screw cover on the right side of the projector. (Illustration #1)
5
Remove the screw on the right side of the projector. (Illustration #2)
6
Push and slide the top cover (Illustration #3) and then open the top
cover.(Illustration #4)
7
Remove the two screws that secure the lamp module (Illustration #5) and
pull up the lamp bar.(Illustration #6)
8
Pull out the lamp module by force. (Illustration #7)
To replace the lamp module, reverse the previous step.
Warning: To reduce the risk of personal injury, do not drop the
lamp module or touch the lamp bulb. The bulb may shatter and
cause injury if it is dropped.
Advertisement
Table of Contents
