Table of Contents
Advertisement
3.3 Operation Mode
You can setup different modes to LAN and WLAN interface for NAT and bridging function.
Gateway:
In this mode, the device is supposed to connect to internet via ADSL/Cable Modem.
The NAT is enabled and PCs in LAN ports share the same IP to S|ISP through WAN port. The
connection type can be setup in WAN page by using PPPoE, DHCP client, PPTP client, L2TP
client or static IP.
Bridged:
In this mode, all Ethernet ports and wireless interface are bridged together and NAT
function is disabled. All the WAN related function and firewall are not supported.
Wireless ISP:
In this more, all Ethernet ports are bridged together and the wireless client will
connect to ISP access point. The NAT is enabled and PCs in Ethernet ports share the same IP
to ISP through wireless LAN. You must set the wireless to client mode first and connect to the
ISP AP in Site-Survey page. The connection type can be setup in WAN page by using PPPoE,
DHCP client, L2TP client or static IP.
32
Advertisement
Table of Contents
