Advertisement
User Manual
MITSUMI WiFi Module
MODEL DWM-W014
The purpose of this manual is to explain correct way how to integrate module
DWM-W014 to the end product. It includes procedures that shall assist you to avoid
unforeseen problems. This manual presents information that shows how module and
OEM product, where module integrated, complies with regulations in certain regions. Any
modifications, not expressly approved by the manufacturer could void the authority to
operate in these regions.
The MITSUMI WiFi Module, model DWM-W014 has to be installed and used in accordance
with the technical description/installation instructions provided by the manufacturer.
For detail information concerning type approval of this module (e.g. where this module is
already pre-approved) please contact the authorized local distributor or the
manufacturer.
The system may only be implemented in the configuration that was authorized. Note that
any changes or modifications to this equipment not expressly approved by the
manufacturer could void the user's authority to operate this equipment.
Advertisement
Table of Contents
Related Manuals for Mitsumi DWM-W014
Summary of Contents for Mitsumi DWM-W014
- Page 1 MODEL DWM-W014 The purpose of this manual is to explain correct way how to integrate module DWM-W014 to the end product. It includes procedures that shall assist you to avoid unforeseen problems. This manual presents information that shows how module and OEM product, where module integrated, complies with regulations in certain regions.
- Page 2 Regulatory Information Operational Information Wireless Interoperability The end product integrating this module is designed to be interoperable with any wireless LAN product that is based on direct sequence spread spectrum (DSSS) and orthogonal frequency division multiplexing (OFDM) radio technology and to comply with the following standards.
- Page 3 Labeling MITSUMI WiFi module DWM-W014 labelled as below. FCC ID: EW4DWMW014 The proposed with FCC ID label format is to be placed on the module. If FCC ID is not visible when the module is installed into the system, “Contains FCC ID: EW4DWMW014”...
- Page 4 This device must not be co-located or operating in conjunction with any other antenna or transmitter.
- Page 5 Canada-Industry Canada (IC) This device complies with RSS 210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of this device.
- Page 6 Europe-EU Declaration of Conformity and Restrictions Hereby, MITSUMI declares that this Mitsumi WiFi module DWM-W014 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. This equipment is marked with the symbol and can be used throughout the European community.
Need help?
Do you have a question about the DWM-W014 and is the answer not in the manual?
Questions and answers