Device Disposal - nuskin ageLOC Boost User Manual

CLEANING ANd CARING FOR YOUR
AGELOC BOOST dEVICE
agelOC Boost should be cleaned according to these instructions after each use to avoid the
accumulation of residue. after every application, rinse agelOC Boost conductive surface under
running water to ensure debris and product is removed from crevices. thoroughly wipe the
device dry with a soft washcloth. store in a dry place.
12
TROUBLESHOOTING
If the microcurrent conductivity is temporarily lost, the
loSS of coNducTIvITy duRING uSAGE:
device ' s leD light bar will flash in continuous sets of five short flashes coupled with five sharp
vibrations. If this happens, apply more agelOC Boost activating serum to the device ' s
conductive surface. swipe up along the touch surface to resume application.
swipe up slowly from the bottom of the device along the full length of
uNRESPoNSIvE dEvIcE:
the touch surface. If the device still does not respond, charge it fully and try again. If the device
still fails to respond, contact nu skin support services.
the bottom light on the device will turn amber. Charge the device.
loW BATTERy:
the amber light at the bottom of agelOC Boost will flash repeatedly
ExTREmE loW BATTERy:
when the user attempts to start an application. this indicates there is not enough battery
remaining to perform an application, and the device will turn off. Charge the device.

dEVICE dISPOSAL

You must dispose of agelOC Boost properly according to local laws and regulations. agelOC
Boost contains electronic components and a lithium-polymer battery, which requires disposal
separate from household waste. When agelOC Boost reaches its end of life, contact your local
waste management department to learn about proper disposal and recycling options.
Dispose of Batteries Properly for Your area
13