Before You Begin; Charging Your Ageloc Boost Device - nuskin ageLOC Boost User Manual

BEFORE YOU BEGIN

Please read all safety and technical information before operating agelOC Boost.
CHARGING YOUR AGELOC BOOST™ dEVICE
Fully charge agelOC Boost before using for the first time.
Before charging, make sure both the device and the magnetic charger are completely dry.
Place the device on the magnetic charger (in the correct position, see diagram). make sure the
magnets snap into position. Plug the UsB cable into a power source.
Charge agelOC Boost completely.
6
When charging begins, agelOC Boost will vibrate once and the leD light bar will slowly cycle
up—this indicates the device is charging and displays the current level of battery charge.
after two minutes, the light bars will glow on and off to indicate the current battery level. Once
the device is fully charged, the lights will stop glowing on and off and the leD light bars will
remain dimly lit.
agelOC Boost is charged using inductive charging. always use the provided charger to charge
the device. Do not attempt to charge using any other inductive charger. If damaged, contact nu
skin support services.
7