Getting Started; Setting Up - Panasonic 2 Line KX-TG9541C Operating Instructions Manual

Setting up

Connecting the AC adaptor
n Base unit
Connect the AC adaptor plug to the unit until
you hear a click.
Connect the AC adaptor to the power outlet.
Note:
R Use only the supplied Panasonic AC adaptor
PNLV234.
1
2
R Follow the directions on the display to set up
the unit.
Connecting the telephone line cord
Refer to one of the following methods depending
on your situation:
– To connect to a 2-line telephone jack: page 9
– To connect to 2 single-line telephone jacks:
page 9
– If you use the unit as a single-line telephone
only: page 9
Connect the telephone line cord until it clicks into
the base unit and telephone line jack.
To connect to a 2-line telephone jack
Connect the "GREEN" plug telephone line
cord (4-wire cord) (
TG9541C(en)_0723_ver012.pdf 9
1
) to the unit, then to the
2-line telephone jack (RJ14C) (
hear a click.
1
"GREEN" plug
1
2
To connect to 2 single-line telephone jacks
For Line 1: Connect the "Transparent" plug
telephone line cord (2-wire cord) (
unit, then to the Line 1 single-line telephone
2
jack (RJ11C) ( ) until you hear a click.
For Line 2: Connect the "GREEN" plug
telephone line cord (4-wire cord) (
unit, then to the Line 2 single-line telephone
4
jack (RJ11C) ( ) until you hear a click.
1
"Transparent" plug
1
2
4
If you use the unit as a single-line telephone
only
Be sure to connect the telephone line cord to LINE
1/2. Change the line selection mode from "Auto"
to "Line1" (page 17).
Connect the "Transparent" plug telephone line
1
cord (2-wire cord) ( ) to the unit, then to the
single-line telephone jack (RJ11C) (
you hear a click.
1
1
2
Note:
R "Check tel line2" is displayed on the unit.
To erase it, see page 64.
2013/07/23

Getting Started

2
) until you
1
) to the
3
) to the
2
3
"GREEN"
plug
2
) until
"Transparent" plug
9
12:24:51