1. Introduction 1.1 Safety The High Performance Tilting Blenders are machines simple to use and to clean. However for your safety read the following instructions in order to avoid accidents: 1.1.1 Always unplug the machine when cleaning, servicing or when any other operation is needed.
1.3 Technical Characteristcs TABLE - 01 Technical Data Units LAR-25PMB Voltage 110/220 Frequency [Hz] 50 or 60 [CV] Power Rating 1,0 or 1.5 Consuption [kW/h] 0,73 or 1,1 Height [mm] 1180 [mm] Width [mm] Depth Net Weigth [kg] 20,5 Gross Weigth [kg] Rotation [ rpm]...
5.2 Electric Diagram Picture -02 01 - Motor 02 - Pedal Lock. IMPORTANT Before doing any maintenance in the machine switch it OFF and unplug it. 3. Operation 3.1 Starting The Blender is activated by turning the On/Off Switch Nº03 (Pic.01) to ON position.
4.6 Maintenance NOTE 4.6.1 Danger Due to turbulence generated when machine is ON do not turn it ON Any maintenance with the machine in working situation is without the Lid Nº01 (Pic.01). The processing time depends on the dangerous. TURN IT OFF BY PULLING THE PLUG OFF THE SOCKET kind of product.
Page 7
4.3 Routine Inspection 3.4.1Cautions with Stainless Steel: 4.3.1 Advice The Stainless Steel may present rust signs, which ARE ALWAYS CAUSED When checking the tension of the belts or chains, DO NOT BY EXTERNAL AGENTS, especially when the cleaning or sanitization is not introduce your fingers between the belts and the pulleys and nor constant and appropriate.
4.1.3 Advices 4. General Safety Practices In case of power shortage, immediately turn the machine OFF. IMPORTANT Use recommended or equivalent lubricants, oils or greases. If any item from the GENERAL SAFETY NOTIONS section is not Avoid mechanical shocks as they may cause failures or malfunction. applicable to your product, please disregard it.
Need help?
Do you have a question about the LQS0025 and is the answer not in the manual?
Questions and answers