Recognition Systems HandPunch 3000 Installation, Operations And User's Manual page 13

HandPunch 3000/4000 Operations and User's manual
If the display shows ** TRY AGAIN ** you not verified. You may have made an error
entering your ID number or placing your hand. Re-enter your ID number and try again,
taking care to place your hand properly. If you wear rings, be sure that the stone is facing up
in the normal position.
If it displays TIME RESTRICTION, you are not authorized to punch in at the this time. If
this seems in error, see your supervisor about time restrictions.
After a pre-programmed number of denied attempts, ID number will no longer be accepted,
and the display will show:
This is called a "lockout." Before the rejected number can be used again, another employee
or a supervisor must successfully verify at the reader.
If you enter an ID number, but do not place your hand on the platen, the unit will time out in
about 25 seconds. You can reset the unit by pressing CLEAR.
The LCD display, the audible beeper, and verification lights on the top panel show data entry
and acceptance information:
Audible beeps and red/green light display
Operation
During keypad entry
After ID entry
After ID entry
After hand placement
After hand placement
After hand placement
12
ID INVALID
TEMPORARILY
Beeps Red light/Green light
1/stroke None
None None
2 None
1 Green
2 Red
1 long Red
Meaning
Keypad stroke accepted
OK, proceed
ID number not in database
ID Verified
ID not verified, try again
ID refused