Table of Contents
Advertisement
1. Mounting and Detaching the Lens
See your camera's instructions for details on
mounting and detaching the lens.
¡After detaching the lens, place the lens with the
rear end up to prevent the lens surface and
electrical contacts from getting scratched.
¡If the contacts get soiled, scratched, or have
fingerprints on them, corrosion or faulty
connections can result. The camera and lens
may not operate properly.
¡If the contacts get soiled or have fingerprints on
them, clean them with a soft cloth.
¡If you remove the lens, cover it with the dust
cap. To attach it properly, align the lens mount
K index of the dust cap as shown
index and the
in the diagram, and turn clockwise. To remove it,
reverse the order.
ENG-4
The lens mount has a rubber ring for enhanced
water- and dust-resistance. The rubber ring may
cause slight abrasions around the camera's lens
mount, but this will not cause any problems. If the
rubber ring becomes worn, it is replaceable by a
Canon Service Center at cost.
2. Close-up Photography (Macro Photography)
The lens can focus as close as 0.45 m/1.5 ft for
close-ups (macro photography).
To focus at 0.45 m/1.5 ft, set the lens focus mode
switch to MF. Look through the viewfinder and
move your body forward or back to focus. Take the
shot when the subject is in focus.
Advertisement
Table of Contents
