Tilt Lock Mechanism; Tilt Support Lever For Power Trim And Tilt Or Hydro Tilt Model; Cowling Lock Lever (Pull Up Type) - Yamaha F80B Owner's Manual

Components
EMU26312

Tilt lock mechanism

The tilt lock mechanism is used to prevent the
outboard motor from lifting out of the water
when in reverse gear.
1. Tilt lock lever
To lock it, set the tilt lock lever in the "
(lock) position. To release, push the tilt lock le-
ver in the " " (release) position.
EMU34461
Tilt support lever for power trim and
tilt or hydro tilt model
To keep the outboard motor in the tilted up po-
sition, lock the tilt support lever to the clamp
bracket.
26
1. Tilt support lever
ECM00660
NOTICE
Do not use the tilt support lever or knob
when trailering the boat. The outboard mo-
tor could shake loose from the tilt support
and fall. If the motor cannot be trailered in
the normal running position, use an addi-
tional support device to secure it in the tilt
position.
EMU26384
"

Cowling lock lever (pull up type)

To remove the engine top cowling, pull up the
cowling lock lever(s) and lift off the cowling.
When installing the cowling, check to be sure
it fits properly in the rubber seal. Then lock the
cowling by moving the cowling lock lever(s)
downward.